Design & Measurement
A good structure is born on the drawing board, not in the repair shop. PreOne offers design, inspection, and measurement services for piping and equipment solutions to ensure every part fits, works, and lasts.
Strengths in design and measurement
-
3D modeling and design: Piping and structures are modeled based on the client’s process data – error prevention starts in the design phase.
-
Measurement and inspection: Precise measurements and installation tolerances ensure a millimeter-perfect result.
-
Consulting and expert support: We assist with material selection, welding methods, and manufacturability as early as the design phase.
-
Complete documentation: All design and measurement stages are documented as part of the project’s quality chain.
Let’s start your project the right way – with precision and a plan.
Seamless integration of design and execution
The quality of design is evident in how few surprises occur during the installation phase.
At PreOne, design, modeling, and measurement are an integral part of the entire supply chain – not a separate phase, but a process that runs from start to finish. We combine practical experience, material knowledge, and technical modeling so that every structure fits into place without on-site modification or compromise.
Our services include 3D design, layout inspection, installation measurement, and technical consulting for both new investments and modernizations. We utilize modern measuring equipment and software to keep tolerances under control and verify structural connection points even before manufacturing. This reduces unnecessary interruptions and significantly shortens installation times.
Information regarding design and execution flows as a single entity – from material selection to welding methods, part numbers, and quality control. Every part is documented, and if necessary, detailed measurement reports are provided to the client before installation.
The result is a solution that requires no adjustment or fitting on site – only commissioning. When design and execution are in the same package, risks are lower and schedules hold better.
